Panasonic EY7441 - Lever and Speed Control

- 8 -
6ZLWFKDQG)RUZDUG5HYHUVH
/HYHU2SHUDWLRQ
&$87,21
To prevent damage, do not operate
Forward/Reverse lever until the bit
comes to a complete stop.
)RUZDUG5RWDWLRQ6ZLWFK
2SHUDWLRQ
1. Push the lever for forward rotation.
2. Depress the trigger switch slightly to
start the tool slowly.
3. The speed increases with the amount
RIGHSUHVVLRQRIWKHWULJJHUIRUHI¿FLHQW
tightening of screws and drilling.
The brake operates and the chuck
stops immediately when the trigger is
released.
4. After use, set the lever to its center
SRVLWLRQVZLWFKORFN
5HYHUVH5RWDWLRQ6ZLWFK
2SHUDWLRQ
1. Push the lever for reverse rotation.
Check the direction of rotation before
use.
2. Depress the trigger switch slightly to
start the tool slowly.
3. After use, set the lever to its center
SRVLWLRQVZLWFKORFN
Forward Reverse
Switch lock
&OXWFK7RUTXH6HWWLQJ
Adjust the torque to one of the 18 clutch
settings or “
´SRVLWLRQ(<
Adjust the torque to one of the 18 clutch
settings or “
”, “ ´SRVLWLRQ(<
127(
Always make sure to stop operation
of the tool and disengage it from the
work, when you select Hammering
mode from Drilling mode or when
you shift to Drilling mode from
Hammering mode by rotating clutch
handle.
&$87,21
Set the clutch setting at this mark ( 
before actual operation.
6SHHG6HOHFWLRQ
Choose a low or high speed to suit the
use.
The more the variable speed control
trigger is pulled, the higher the speed
becomes.
&$87,21
&KHFNWKHVSHHGVHOHFWRUVZLWFK
L
EHIRUHXVH
8VHDWORZVSHHGZKHQKLJKWRUTXH
L
LVQHHGHGGXULQJRSHUDWLRQ8VLQJ
DWKLJKVSHHGZKHQKLJKWRUTXH
LVUHTXLUHGPD\FDXVHDPRWRU
EUHDNGRZQ
'RQRWRSHUDWHWKHVSHHGVHOHFWRU
L
VZLWFK/2:+,*+ZKLOHSXOOLQJRQ
WKHVSHHGFRQWUROWULJJHU7KLVFDQ
FDXVHWKHUHFKDUJHDEOHEDWWHU\WR
ZHDUTXLFNO\RUGDPDJHWKHLQWHUQDO
PHFKDQLVPRIWKHPRWRU
* See specifications for “MAXIMUM
RECOMMENDED CAPACITIES”.
/2:
+,*+