Panasonic FV-05VFL2 - Separate Blower and Body Mounting

Make sure that adaptor claws are properly inserted
into body slots.
IMPORTANT:
5. Insert the fan body into joists. (Fig.9)
6. Secure the fan body to adaptor by using thumb
screw and plug connector to receptacle(Fig.10)
Fig. 9
When mounting
body and blower
separately
1. Loosen 4 screws (but
do not remove them
from blower). (Fig.12-1)
2. Remove blower section.
(Fig.12-2)
4. Insert fan body (without
blower section) into joists
(Fig.9)
5. Secure the adaptor to
fan body by using thumb
screw. (Fig.10)
7. Insert the blower into the
fan body. (Fig.12-3)
8. Secure the blower.
(Fig.12-4) and plug
connector to receptacle
(Fig.10)
3. Remove adaptor from
fan body and secure it
to joists as in Fig.8 of
page 8.
Fig.12-2
Fig.12-3
Fig.12-1
Fig.12-4
Slots
Adaptor
claws
Fan body
Joist
9
7. Secure to joists by using
long screws(M4X30) and secure it to fan body by
using screw (M4X12) in vertical direction (Fig.11)
the suspension bracket
II
8. Follow steps 8 to 11 of Installation (page 8) to
complete the installation work.
I
Conduit
Junction box cover
Circular duct
4. Insert to fan body (refering
to step 2 of installation , page 6)
the suspension bracket in
I
6. Secure the fan body
to joists by using long
screw(M4X30) (Fig.11)
Fig. 10
Thumb
screw
Plug connector I
Receptacle I
4-Screws
Screw driver
Fan body
Adaptor
4-Screws
Fan body
Blower
Duct tape
or clamps
Fig. 11
2-Long screws
(M4X30)
screw (M4X12)II