5
CAUTION
l
Attach the Velcro straps securely. Otherwise, the computer may fall off.
l
If the hand strap loosens, the computer may fall down.
l
Do not use the strap if it becomes worn or damaged.
l
Before using, check if the mounting clips and the screws have been rmly xed.
NOTE
l
The supplied digitizer pen can be stored in the leather case as illustrated on the
right.
n
When Cleaning inside of the dust cover
A
Remove the edge of hand strap passing through the clip.
B
Tip the clip back to pull it out of the computer.
C
Open up the whole hand strap.
n
When Disposing of the computer
A
Open the hand strap by following the steps
A
-
C
in “When Cleaning inside
of the dust cover”.
B
Remove the 4 screws xed to the board using a Phillips head screwdriver
and remove the board.
C
Remove the battery pack.
n
Using the hand strap
A
When using the computer holding with hand, insert your hand to (A) part of
the hand strap.
B
Fix the hand strap rmly so that the computer does not come off, and then
turn it over.
CAUTION
l
If the hand is not securely xed to the hand strap, the computer may drop.
n
Adjusting the hand strap
When the hand strap is too loose or too tight, you can adjust the hand strap according to the instructions below.
A
Remove (A) from the strap joint and next remove (B).
B
Adjust the position (C) and put (B) and (A) back in place.
n
Removing the leather case from the computer
Perform the steps in the reverse order.
Before removing the leather case, always make sure you close the DC-IN Jack cover. Failing to close the DC-IN Jack
cover when removing the case may cause damage to the leather case and cover.
㪘
㪙㪘
DFQW5A50ZAT_FZ-G1mk1_Addendum_14L.indb 5 2014/11/27 11:27:19
To Next Page
Loading...
