23
(ENG) SQT0885
4 Attach this unit to the Multi Mount as
shown in the figure.
≥ Before attaching this unit, fasten the Multi Mount securely with the band and the hook and loop
fastener.
1 While holding the tightening nut A, tighten the
adjustment knob B by rotating it towards LOCK.
2 While holding the adjustment knob B, loosen the
the adjustment belt C until this unit can be passed
through it by rotating the tightening nut A
towards UNLOCK.
3 Pass this unit through the adjustment
belt C so that this unit is in the position
shown in the figure.
4
While holding the adjustment knob
B
, tighten the
adjustment belt
C
by rotating the tightening nut
A
towards LOCK until this unit is fastened securely.
≥ Adjust the adjustment belt with hands. Do not apply too much
force.
≥ Do not rotate the tightening nut more than necessary after
fastening this unit.
≥ Check the left/right tilt of this unit after fastening it.
≥ To correct the left/right tilt of this unit, loosen the adjustment belt.
Attaching this unit to the Multi Mount
LOCK
HX-A1M-SQT0885_mst.book 23 ページ ２０１５年４月６日 月曜日 午前９時４４分
To Next Page
Loading...
