Registering a camera unit
Y
ou must register the camera unit to your monitor unit before it can be
used.
1 Monitor unit:
MMENUN a MbN: “Camera Management” a MOKN a MbN: “Add
Camera” a MOKN
R An operation guide is displayed. Press MOKN to continue.
R Complete the following step within 90 seconds.
2 Camera unit:
Press and hold M
N
for 3 seconds until the LED indicator starts
blinking.
Note:
R A
message is displayed on the monitor unit to show if the registration
was successful or not, and a beep sounds.
LED indicator
Y
ou can use the LED indicator to confirm the camera unit’s status.
LED indicator Status
Off No power
Green, lit Normal operation
Green, blinking slowly Registration mode
Green, blinking quickly Device malfunction
4
Installation
HNC301_US_C_(en_en)_0720_ver.030.pdf 4 2018/07/20 12:37:05
To Next Page
Loading...
