Panasonic KX-HNC800 - Page 22

to your device. It can help
you identify your mobile
device when performing
certain operations, such as
deregistering a mobile
device.
R A list of all cameras
registered to the app is
displayed when initial setup
is complete.
Information for current hub
u
s
e
rs
If your mobile device is already
registered to a hub and you want
to use your camera by itself (i.e.,
you do not want to integrate the
camera with your Panasonic
Home Network System), perform
the following.
1 Plug in the camera and wait
about 1 minute for the
camera’s LED to light in green.
R If the LED does not light in
green, or if you experience
trouble during this
procedure, reset the
camera (page 25) and
then repeat this procedure.
2 Start the [Home Network]
app.
3 From the [Home Network]
app home screen, tap
[Settings].
4 Tap [Device Registration] ®
[
Registration] ® [HD
Camera] ® [Method 2].
5
iPhone, iPad users
Continue from step 4 of the
initial setup procedure on
page 19.
Android device users
Continue from step 4 of the
initial setup procedure on
page 21.
22
For assistance, please visit http://shop.panasonic.com/support
Setup
HNC800_(en_en)_0902_ver.220.pdf 22 2016/09/05 17:54:31