Menu Guide
64
DVQX1749 (ENG)
2 Select frames to combine.
Recorded motion picture and 4K burst files can be divided in two. It is recommended for
when you want to divide a part you need with a part you do not need.
Dividing a file is permanent. Decide before you divide!
1 Press 2/1 to select the file to divide, and then press [MENU/SET].
Select the frames so that the moving subject will not overlap on the preceding or subsequent
frames. (The sequence composition may not be created properly if the subject overlaps.)
1 Drag the slide bar or use 3/4/2/1 to select the
frames to combine.
2 Press [MENU/SET].
• The selected frames are remembered, and the display
goes to the preview screen.
• Press 3/4 to select items and press [MENU/SET] to
perform the following operations.
–[Next]:
Lets you select more frames for combining.
– [Reselect]:
Discards the frame selected immediately before and lets you select a different image.
3 Repeat steps 1 and 2 to select more frames to combine.
• You can select 3 to 40 frames.
4 Press 3/4 to select [Save], and then press [MENU/SET].
¥
Pictures are saved in JPEG format. Recording information (Exif information) of the first frame
such as shutter speed, aperture, and ISO sensitivity are also registered.
Tips for [Sequence Composition]
We recommend using a tripod to take pictures for [Sequence Composition].
[Video Divide]
> [Playback] > [Video Divide]
2 Press 3 at the location to divide.
• You can finely adjust the location for division by pressing
2/1 while the file is paused.
3 Press 4.
• The file may be lost if the card or battery is removed while
processing the dividing.
¥ It may not be possible to divide a file at a point near the beginning or end.
¥ This function is not available in the following case:
– When the recording time is short.
DC-G95PP-DVQX1749_eng.book 64 ページ ２０１９年３月２９日 金曜日 午後１時３１分
To Next Page
Loading...
