2. Getting Started/Basic Operations
46
Temporarily changing the items assigned to the front/rear dials ([Dial Operation
Switch])
You can temporarily change the items assigned to the front/
rear dials using the function button to which [Dial Operation
Switch] is assigned.
[Dial Operation Switch] is assigned to [Fn1] at the time of
purchase. (P60)
• You can set the items to be assigned temporarily to the front/
rear dials in [Dial Operation Switch Setup] in [Dial Set.] in the [Custom] ([Operation]) menu.
(P47)
1 Press [Fn1].
• A guide will be displayed showing the items temporarily
assigned to the front/rear dials.
• If no operations are performed, the guide will disappear in
a few seconds.
2 Rotate the front/rear dials while the guide is
displayed.
• The settings of the items assigned to the dials will change.
3 Press [MENU/SET] and set.
• You can also complete this step by performing either of the operations below:
– Press the shutter button halfway
– Press [Fn1]
• Items that are temporarily assigned to the front/rear dials can be used only while the guide
(step
1) or setting screen (step 2) is displayed.
989898
0
ISOISOISOISO
WBWBWBWB
AWBc
WBWBWBWBWBWBWBWBWBWBWB
AWBAWB
ISOISOISOISO
To Next Page
Loading...
Need help?
General
