123
4K Photo and Drive Settings
Recording with the 4K Photo function and selecting pictures to save
■
Setting Pre-Burst Recording ([4K Burst]/[4K Burst(S/S)])
The camera starts recording approximately 1 second before the shutter button is pressed
fully, so you will not miss a photo opportunity.
→ [Rec] → [4K PHOTO] → [Pre-Burst Recording]
Settings: [ON] / [OFF]
●
When this function is enabled, [ ] is displayed on the recording screen.
●
Auto Focus operation settings and menus that cannot be set while this function is in use are the
same as those during [4K Pre-Burst] operation.
■
Setting Loop Recording ([4K Burst(S/S)])
You can perform recording while deleting the oldest recorded data, allowing you to keep
on recording while waiting for a photo opportunity without replacing the card.
• Once you start recording, the 4K burst file will be recorded and divided approximately
every 2 minutes.
Approximately the last 10 minutes (up to approximately 12 minutes) will be saved. The
preceding part will be deleted.
→ [Rec] → [4K PHOTO] → [Loop Recording(4K PHOTO)]
Settings: [ON] / [OFF]
●
We recommend that you use a sufficiently charged battery or an AC adaptor (optional) and
DC coupler (optional).
●
Up to 29 minutes and 59 seconds of continuous recording is possible.
●
When this function is enabled, [ ] is displayed on the recording screen.
●
[Loop Recording(4K PHOTO)] is not possible when there is insufficient free space on the card.
■
To cancel the 4K Photo functions
In step
2
, select [ ] ([Single]) or [ ].
Battery drainage and camera temperature
●
If the surrounding temperature is high or 4K photos are recorded continuously, [ ] may be
displayed and recording may be stopped halfway through. Wait until the camera cools down.
●
When [ ] ([4K Pre-Burst]) or [Pre-Burst Recording] is set, the battery drains faster and the
camera temperature rises.
Select [
] ([4K Pre-Burst]) or [Pre-Burst Recording] only when recording.
To Next Page
Loading...
Need help?
General
