12
VQT2B45 (ENG)
Inserting/Removing the Battery/Card
(Optional)
• Check that the camera is turned off.
• We recommend using a Panasonic card.
1
Slide the release lever in the direction of
the arrow and open the card/battery door.
• Always use genuine Panasonic batteries (DMW-
BCF10PP).
• If you use other batteries, we cannot guarantee
the quality of this product.
2
Battery: Insert it fully being careful about
the direction for insert. Pull the lever
A
in the direction of the arrow to remove
the battery. Card: Push it fully until it
clicks being careful about the direction
for insert. To remove the card, push the
card until it clicks, then pull the card out
upright.
B
Do not touch the connection terminals of the
card.
• The card may be damaged if it is not fully
inserted.
3
1
: Close the card/battery door.
2
: Slide the release lever in the direction
of the arrow.
• If the card/battery door cannot be completely
closed, remove the card, check its direction and
then insert it again.
Note
• The battery may swell and its operating time may become shorter as the number of
times it is charged increases. For long term battery use, we recommend you do not
frequently charge the battery before it is exhausted.
• The performance of the battery may temporarily deteriorate and the operating time may
become shorter in low temperature conditions (e.g. skiing/snowboarding).
VQT2B45DMC-FS42P-PCEN.indd12VQT2B45DMC-FS42P-PCEN.indd12 2009/04/0713:53:252009/04/0713:53:25
To Next Page
Loading...
Need help?
General
