Advanced (Recording pictures)
For details on [REel Mode menu settings, refer to P32.
Contrast and exposure will be adjusted automatically when there is a big difference in
brightness between the background and subject, to bring the image close to how you see.
Applicable modes: [_[__
[OFF]I[LOW]I[STANDARD]I[HIGH]
• Even when the [SENSITIVITY] is set to [ISO100]/[ISO125], [SENSITIVITY] may be set higher
than [ISO100]/[ISO125] if the picture is taken with [I.EXPOSURE] set to valid.
• Compensation effect may not be achieved depending on the conditions.
• [i(]D] in the screen turns to yellow when [I.EXPOSURE] is in effect.
• [LOW], [STANDARD], or [HIGH] represents the maximum range of effect.
For details on [REel Mode menu settings, refer to P32.
It will select optimal ISO sensitivity with set value as limit depending on the brightness of
the subject.
Applicable modes: []__
[0FF]11200]11400]11800]111600]
• The upper limit of the ISO sensitivity can be set.
• The higher the value set for the ISO sensitivity, the more the jitter is reduced but the greater the
amount of picture noise.
• It will work when the [SENSITIVITY] is set to [AUTO] or [alS0].
For details on [REel Mode menu settings, refer to P32.
ISO sensitivity settings between [ISO100] and [ISO6400] are changed for every 1/3 EV.
Applicable modes: [_][___
[1/3 EV]: [100]/[125]/[160]/[200]/[250]/[320]/[400]/[500]/[640]/[800]/[1000]/[1250]/
[1600 ]![2000 ]![2500 ]![3200 ]![4000]![5000]![6400]
[1 EV]: [100]![200]![400]![800]![1600]![3200]![6400]
• When the setting is changed from [1/3 EV] to [1 EV], ISO sensitivity will be set to value closest
to the value set during the [1/3 EV]. (Set value will not restore when the setting is changed back
to [1/3 EV]. It will stay as the setting selected for [1 EV].)
VQT2S30 131
To Next Page
Loading...
