Others
• When recording under fluorescent or LED lighting fixture etc., increasing the shutter speed may
introduce slight changes to brightness and color. These are a result of the characteristics of the
light source and do not indicate a malfunction.
• This is a characteristic of CCDs, and it appears when the subject has a
bright part. Some unevenness may occur in the surrounding areas, but
this is not a malfunction.
it is recorded in motion pictures but is not recorded on still pictures.
• It is recommended that when you take pictures you take care not to
expose the screen to sunlight or any other source of strong light.
• Use a card with SD Speed Class with "Class 4" or higher when recording motion pictures.
• Depending on the type of the card, recording may stop in the middle.
If motion picture recording stops during use of a card of at least "Class 4" or if you use a
card that has been formatted on a PC or other equipment, the data-writing speed is lower.
In such cases, we recommend that you make a backup of the data and then format (P52)
the card in this unit.
• Set the AF area to the distinctive color of the subject if there is a part that is different from the
surrounding color. (P87)
- 142-
To Next Page
Loading...
