Others
• This phenomenon appears when you press the shutter button halfway to set the aperture value
and does not affect the recorded pictures.
• This phenomenon also appears when the brightness changes when the camera is zoomed or
when the camera is moved. This is because of operation of the automatic aperture of the
camera, and it is not a malfunction.
• The LCD monitor may flicker for a few seconds after the power is turned on. This is an
operation to correct flicker caused by lighting such as fluorescent lights, LED lights, etc. and is
not a malfunction.
• Is [LCD Mode] active? (P48)
• Perform [LCD Display]. (P47)
• This is not a malfunction.
These pixels do not affect the recorded pictures.
• In dark places, noise may appear to maintain the brightness of the LCD monitor. This does not
affect the pictures you are recording.
- 144 -
To Next Page
Loading...
