●
When reconnecting the water tap
adaptor, turn
A
part to the left until
4 mm of screw thread become
visible. Then, do the procedure.
NOTE
●
Ask a service person for grounding work.
■
Adjusting height with the adjustable leg knob.
1)
Turn the adjustable leg knob to the left side and loosen
as indicated with the left pointing arrow. Then, turn the
adjustable leg to adjust the levelness.
2) Turn the adjustable leg knob to the right side and fi x
as indicated with the right pointing arrow.
Adjustable leg
knob
TightenLoosen
Adjustable leg
To raise
To lower
1
Connect the water tap adaptor
to the faucet.
1) Loosen 4 screws.
2) Connect to the faucet and tighten the
screws.
2
Fix.
●
Turn
A
part to the right side and
tighten securely.
(To prevent water leak)
3
Connect the water supply hose
to the water tap adaptor.
●
Pushing down the lever, insert and hook
the claw of the lever on the fl ange of the
adaptor.
4
Connect the water supply hose
to the water supply valve screw.
●
Slightly lift up the elbow and tighten the
nut.
●
Check if the elbow is not loose.
Elbow
Water supply
valve screw
Nut
A
part
Screw
thread
Lever
CAUTION
●
Tighten the nut fi rmly.
(To prevent water leak)
●
Do not forcibly bend the water
supply hose.
(To prevent water leak caused by
the bent hose)
Lever
Claw
Flange
To Next Page
Loading...
