Panasonic NI-33GX

(Continued from page 5)
4. (NI-42GX/43GX/44GX/45GX)}
Preheat the iron usually in about 1-2 minutes.
(NI-33GX/G10NR Only)
Preheat the iron until the indicator light goes out. This light will go on and off during ironing
to indicate the temperature chosen by the selector dial is being maintained.
5. Hold the iron horizontally and press the steam button into the steam position.
Steam button is regulated as follows.
NOTE: 3 position steam button.
font > oa fit
Low steam High steam
. KA
(Button UP: for High steam. MED: for Low steam)
Now steam ironing can begin. C
6. Anytime the iron is set vertically the steaming action will stop.
NOTE: Do not use the steam button unless the iron is sufficiently hot enough to produce steam,
otherwise water will leak out through the vents instead.
HOW TO USE AS A DRY IRON
1. Press the steam button down to the dry position.
2. Place the iron vertically, set the selector dial to OFF.
3. Plug in the iron.
4. Set the temperature selector dial to the desired position.
(Refer to the Fabric Ironing Chart in this manual on page 9 )
5. (N1-42GX/43GX/44GX/45GX) Preheat the iron usually in about 1-2 minutes.
(NI-33GX/G10NR Only) Preheat the iron until the indicator light goes out.