Panasonic NN-8500

Glass tray
1. Do not operate the microwave oven without the
roller ring and the glass tray.
2. Do not use any other glass trays for this oven.
3. Ifthe glass tray is hot, allow it to cool before
cleaning or rinsing with water.
4. Do not place the food directly on the glass tray.
5. Do not put any hot food or container.on the cold
glass tray or any frozen food on the hot glass tray.
6. The tray can turn in either direction.
Roller ring
4. The roller ring and oven floor have to be cleaned
frequently to prevent noise and accumulation of
food residues.
2.
When
cooking
always
use
the
roller
ring
together
with
the
glass
tray.
Warning
1. The door seals and door seal areas should be
cleaned with a damp cloth.
The appliance should be inspected for damage to
the door seals and door seal areas and if these
areas are damaged the appliance should not be
operated until it has been repaired by service
technician trained by the manufacturer.
2. Itis dangerous for anyone other than a service
technician trained by the manufacturer to perform
repair service.
3.. Ifthe supply cord of this appliance is damaged, it
must be replaced by the special cord available only
from the manufacturer.
This appliance was produced to BS800.
Oven light
When it becomes necessary to replace the oven light,
please consult your dealer.
Fan motor operation
After using BAKING, COMBINATION and GRILLING
fan motor always rotates for 5 minutes to cool the
electric components. This is normal and you can take
out the food even though fan motor operates. You can
continue using the oven during this 5 minutes on a
manual program. -
Safety Instruction
1. Before using CONVECTION, COMBINATION or
GRILL function for the first time, operate the
oven without food on GRILL, for 20 minutes.
This will allow the oil that is used for rust
protection to be burned off.
2. Exterior oven surfaces, including air vents on
the cabinet and the oven door will get hot
during CONVECTION, COMBINATION and
GRILLING. Use care when opening or closing
door and when inserting or removing food and
accessories.
3. The oven has a heater situated in the top of the
oven.
After using the CONVECTION, COMBINATION
and GRILL functions, these surfaces will be very
hot.
4. Do not operate this appliance if it has a damaged
CORD OR PLUG, if it is not working properly, or if
it has been damaged or dropped.
5. This appliance, including the oven lamp, should be
serviced only by service technician trained by the
manufacturer.
. Do not use outdoors.
. Do not immerse cord, plug or oven in water.
. Keep cord away from heated surfaces.
. Do not let cord hang over the edge of table or worn
top.
10. Do not attempt to tamper with or make any
adjustments or repairs to door, control pane!
housing, safety interlock switches or any other part
of the oven. Do not remove outer panel from oven.
Repairs should only be done by a qualified service
person.
11. The door seals and area around door opening
should be kept clean at all times. Clean with a soft
damp cloth.
12. The appliance should be inspected for damage to
the door seals and door seal areas and if these
areas are damaged the appliance should not be
operated until it has been repaired by service
technician trained by the manufacturer.
13. Itis dangerous for anyone other than a service
technician trained by the manufacturer to perform
repair service.
14. The appliance shall not be operated by
MICROWAVE or COMBINATION WITHOUT
FOOD IN THE OVEN, operation in this manner
may damage the appliance.
©O on oD