NN-CT890SBPQ
25
Note: After breaking off the motor cover, make sure that
cut-off portions are properly trimmed off or bent inside so
that no sharp edges are exposed.
Note: To secure the motor cover use a 4 x 6 screw.
10.8. Quartz Heater
1. Remove the sensor cable from the DPC connector CN7.
2. Remove the exhaust guide A by removing the two screws
shown in figure 10.
3. Disconnect the cables to the grill heater
4. Remove the grill cover by removing the 5 screws in figure
11
5. Remove the two screws holding the grill heater
(Figure12).
6. Loosen the 2 screws holding the ceramic grill holders,
turn the holders to release the grill element.
7. Remove the heater bracket D by using a flat blade screw
driver to lever back the tabs.
8. The grill element can now be removed from inside the
oven.
Removing the exhaust guide and grill cover
Figure 10
Removing the Turntable motor cover
Figure 8
Two screws to remove the turntable motor
To Next Page
Loading...
