NN-CT890SBPQ
27
10.9. Convection Element And Circulation Fan Motor
1. Remove one screw to remove the exhaust guide D. Figure 13.
2. Remove the rear heater cover by removing the three screws. Figure 13
3. Remove the temperature sensor by removing the two screws. Figure 14
4. Remove the power cord.
5. Remove the wire terminals from the circulation fan motor and the convection heater element.
6. Remove the four screws from the oven base. Figure 15
7. Carefully place the oven onto its base and remove the backplate.
8. Remove the nut holding the circulation fan. Figure 16
9. Remove the circulation fan by removing the three screws. Figure 16
10. Remove the convection element by removing the two screws. Figure 16
Removing the rear heater cover
Figure 13
To Next Page
Loading...
