B. REMOVING THE OUTER CASE(Figure 8)
(1) Remove the vent grille by removing two screws
securing it to the outer case.
(2) Remove two screws securing it to the front
bracket.
(3) Remove two screws securing it to the air duct.
(4) Remove the wall mounting plate by removing the
two screws securing it to the outer case.
(5) Remove the base plate by removing six screws
securing it to the outer case. Remove the Mount
from the out case by removing two screws
securing it to the outer case and one screw
securing it to the ventilation motor ASS'Y and
cavity.
(6) Remove the power cord cover from outer case by
removing a screw.
To Next Page
Loading...
