Panasonic NV-DS30B - MOTOR AND SWITCH COMPONENTS

Notes and Hints
WiSelecting Remote Controller Modes
When 2 Movie Cameras are used simultaneously,
they can be operated individually by selecting
different Remote Controller Modes.
If the Remote Controller Mode of the Movie
Camera and that of the Remote Controller do not
match, [REMOTE] Indication is displayed.
Setup on the Movie Camera:
Set [REMOTE] on the [OTHER FUNCTIONS] Sub-
Menu to the desired Remote Controller Mode.
(-> 16)
Setup on the Remote Controller:
[VCR1]: Press the [}>] Button and (il] Button
simultaneously. @
[VCR2]: Press the [«] Button and [lil] Button
simultaneously. @
@When the battery in the Remote Controller is
replaced, the mode is automatically reset to
[VCR1] Mode.
MiConcerning the Power Supply
When the Movie Camera is used for a long time,
the Camera body becomes warm, but this is not a
malfunction.
lf the [CHARGE] Lamp does not light up although
the Battery is attached to AC Adaptor, detach the
Battery and reattach it.
Battery CGP-D110 and CGP-D105 cannot be
charged with this AC Adaptor.
Hilnserting/Removing the Cassette
lf a new Cassette is inserted, rewind to the
beginning of the tape before starting recording.
When inserting the cassette, make sure it faces in
the right direction and then push it in until it stops.
Alarm Sounds
When [BEEP SOUND} on the [OTHER
FUNCTIONS] Sub-Menu on the [CAMERA
FUNCTIONS] Main-Menu is set to {ON},
confirmation/alarm beeps are issued as follows.
1 Beep
When you start recording
When you switch the [VCR/OFF/CAMERA] Switch
from [OFF] to Camera Mode
2 Beeps
When you pause recording
10 Beeps
f you perform a wrong operation before or during
recording
Recording
© Before turning on the power, remove the Lens
Cap. If the Lens Cap is still attached when the
power is turned on, Automatic White Balance
Adjustment (- 51) may not function correctly.
42
WRecording Check
For Recording Check, the recording speed mode
{SP/LP) must be the same as the mode used for
the recording. If different, playback images will be
distorted.
HiPhotoshot
®Photoshot Recording results in slightly inferior
image quality.
Progressive Photoshot Function
©The still pictures are recorded at a slightly
rewound point from where you press the
[PHOTOSHOT] Button.
When you change to the Still Picture Mode, you
will hear a click, This is the sound of the iris closing
and not an indication of malfunction.
lf you record still pictures in Progressive Photoshot
Mode when your Movie Camera is set to
Programme AE (= 26), the brightness of the
images may change.
When you set the following functions,
[PROGRESSIVE] will be set to [OFF].
Digital Effect Modes in [EFFECT] (+ 30)
Digital Zoom [D.ZOOM] {> 23)
@lmage Stabilizer Function [SIS] (- 24)
When [PROGRESSIVE] is set to [ON], the shutter
speed cannot be adjusted to 1/750 s or faster.
(-> 28)
Zoom In/Out Functions
When you are zooming on a faraway subject, a
sharper focus is achieved if the recording subject
is 1.7 metres or more away from the Movie
Camera.
Hi !mage Stabilizer Function
The Image Stabilizer Function does not operate in
a dimly lit place. In this case, the [ ()] indication
lights up.
Under fluorescent lighting, image brightness may
change or colours may not look natural.
*After-images may appear.
When a tripod is used, it is recommended that you
turn the Image Stabilizer off.
Hi Cinema Function
If you play back tape recorded in Cinema Mode on
a wide-screen (16:9) format TV, playback size is
automatically adjusted to fit the TV screen format.
Please refer to the TV's operating instructions for
details.
When images are displayed on a TV screen, the
Date/Time Indication may be erased in some
cases.