Panasonic NV-F66A - Page 44

SYMPTOM
CAUSE
FEMEDY
Playback
picture
is not in
colour.
Playback
picture
has
large amounts of "snow"
Reception channelwas not adjusted
correctly during
recording.
Readjust reception channel correctly.
TV
set
is not
properly
tuned to the video
olavback channel of the VTR.
Properly tune the TV set to the video
playback
channelof
the VTR.
The video heads are clogged
with
dirt
Consult
qualif
ied service
personnel.
The video heads are abraded. Consult
qualif
ied service
personnel.
Taoe is old and/or defective.
Use newtape.
Remote Controller
(Digital
Scanner) does not work.
Bemote
Controller
(Digital
Scanneo
is not
being
pointed
at Infra-red ReceiverWindow
on
the VTR.
Point the Remote Controller
(Digital
ScanneO
at lnfra-red Receiver Window on the VTR.
Distance is too far,
Use the Remote
Controller
(Digital
Scanner)
within 7
m from the VTR.
An obstacle is between Remote Controller
Remove obstacle.
(Digital
Scanner)
and VTR.
Batteries
are
exhausted.
Replace batteries.
Battery
polarities (+,
-)
are
reversed. lnsert batteries correctlv.
Bar code reading
with Digital
Scanner
is impossible.
The Digital Scanner is in the
power-saving
standby condition.
Set the Digital Scanner
On/Otf Switch
to
"OFF" and then to
"ON"
again.
The bar code
has
been
iraced too slowlv. Trace
the
bar code
quickly.
The bar code was not traced allthe
wav
from the
Small
Box
Dastthe
last bar.
Trace the bar code correctly.
The bar code was not traced straight.
Trace
the
bar code straight
from lefl to
right.
Bar Code Reading Section
is clogged
with dirt.
Bar
Code
Reading Section
requires cleaning.
(See
page
8.)
The
VTR is turned off.
Turn the VTR on.
Transmission
from the Digital
Scanner
to the VTR cannot be
performed.
The VTR
is in
an oDeration
mode.
Put the VTR into the stoo
mode.
There is no unoccupied timer
programme
number
left.
A maximum ol8
timer recordings can be
programmed
at the same
time.
Reading a bar code
was not followed by a
"beep"
sound
from the Digital
Scanner
Perform the bar code reading again.
The transmission was nol
followed
by a
repeated "beep'sound
from the VTR.
Keep
pressing
the Transmit
Button until
the
confirmation
sound is heard.