Panasonic NV-FJ600 Series - Power Saving Settings; Sound Mode Selection; Direct Recording Function

17
Setting Up
For Reduced the VCR’s Power
Consumption When the VCR Is Switched
Off
Follow steps 1 to 2 of TAPE SELECT.
3 Press the Cursor buttons (
3434
3434
34) T
to select “POWER SAVE” then
select “ON” or “OFF” by pressing
the Cursor buttons (
2 12 1
2 12 1
2 1) T.
ON: This setting makes the
display disappear when
the VCR is off.
It will not operate in the
Timer standby mode.
After recording all
programmed data, the
VCR will go into Power
save mode.
OFF: This setting does not conserve power when the
VCR is off.
4 Press the MENU button V twice to exit the On Screen
Display.
To Set to the Conditions for Direct
Recording Function
Follow steps 1 to 2 of TAPE SELECT.
3 Press the Cursor buttons (
3434
3434
34) T
to select “DIRECT REC” then
select “ON” or “OFF” by pressing
the Cursor buttons (
2 12 1
2 12 1
2 1) T.
OFF: Initially set at this position.
ON: This setting enables
Direct Recording.
AV Input (A1) becomes
exclusive channel for
Direct Recording.
(See page 21.)
4 Press the MENU button V twice to exit the On Screen
Display.
To Select the Sound Mode
(NV-FJ600EA only)
Follow steps 1 to 2 of TAPE SELECT.
3 Press the Cursor buttons (
3434
3434
34) T
to select “MONAURAL” then select
“ON” or “OFF” by pressing the
Cursor buttons (
2 12 1
2 12 1
2 1) T.
≥ Select “ON” to record the
normal sound during a NICAM
broadcast or if the stereo sound
is distorted due to inferior
reception conditions.
4 Press the MENU button V twice
to exit the On Screen Display.
END :MENU
NTSC INPUT SELECT (AUTO)
NTSC PB SELECT (onPALTV)
TAPE SELECT (E180)
SELECT:
POWER SAVE (OFF)
DIRECT REC (OFF)
MONAURAL (ON)
OPTION
NTSC CONVERTER (OFF)
END :MENU
NTSC INPUT SELECT (AUTO)
NTSC PB SELECT (onPALTV)
TAPE SELECT (E180)
SELECT:
NTSC CONVERTER (OFF)
POWER SAVE (OFF)
DIRECT REC (OFF)
MONAURAL (OFF)
OPTION
END :MENU
NTSC INPUT SELECT (AUTO)
NTSC PB SELECT (onPALTV)
TAPE SELECT (E180)
SELECT:
NTSC CONVERTER (OFF)
POWER SAVE (OFF)
DIRECT REC (OFF)
OPTION
END :MENU
NTSC INPUT SELECT (AUTO)
NTSC PB SELECT (onPALTV)
TAPE SELECT (E180)
SELECT:
NTSC CONVERTER (OFF)
POWER SAVE (ON)
DIRECT REC (OFF)
OPTION
END :MENU
NTSC INPUT SELECT (AUTO)
NTSC PB SELECT (onPALTV)
TAPE SELECT (E180)
SELECT:
NTSC CONVERTER (OFF)
POWER SAVE (OFF)
DIRECT REC (OFF)
OPTION
END :MENU
NTSC INPUT SELECT (AUTO)
NTSC PB SELECT (onPALTV)
TAPE SELECT (E180)
SELECT:
NTSC CONVERTER (OFF)
POWER SAVE (OFF)
DIRECT REC (ON)
OPTION