Panasonic Omnivision PV-7450 User Manual

On-Screen Displays (OSD)
Function & Channel Display
When a function button is PLAY
pushed, e.g. PLAY, or you
change channels, a 4 second
display appears first in large
and then small characters.
Menu Screen
1 Push MENU to display
the menu.
uP CHANNEL
ID 1OMA/ LANGUE: ENGLISH
2 Push AV and P to
make your selection.
* To get the most from each feature, please read the
Operating Manual before attempting any operation.
VCR Status & Clock Display
Push DISPLAY to display or
DISPLAY
O remove the overlay shown below.
Y)
Function Status
Current Time
Channel
Rec Time
Remaining
(OTR mode only
see page 16.}
REC 12:00AM
0:25 0:
(STEREO) 4
(SAP
Tape Speed
Broadcast Audio Counter
Being Received
(See page 22.)
(Model PV-7450 only)
* This display will time
out in 5 seconds.
Blank Tape/ No Video Signal Indication
When a blank section of tape comes up in Play
mode, or the selected channel has no broadcast
signal, the TV screen will turn solid blue.
14
Warning and instruction Displays
These displays will alert you of a missed operation or
provide further instructions.
NO CH FOUND
PLEASE CHECK ANTENNA
CABLE CONNECTION THEN
PUSH VCR CH UP KEY AGAIN
If no active channels are
found for CHANNEL
MEMORY...
(See page 12.)
If you attempt to set or
review a Timer Recording
and the Clock is not set...
(See page 18.)
PLEASE SET CLOCK
BEFORE PROGRAMMING
TURN VCR OFF
FOR TIMER RECORDING
After a Timer Program
has been set...
(See page 18.)
If you push REC on the
remote control or VCR,
and a cassette is inserted
with no record tab...
(See page 16.)
CHECK CASSETTE
RECORD TAB
If you push PLAY, FF, REW,
or REC on the remote NO CASSETTE
control or VCR without
a cassette inserted...
(See pages 15, 16.)
PLEASE INSERT A CASSETTE
TO CANCEL TIMÉH REC
PUSH POWER THEN STOP KEY
If you push POWER or
STOP during a Timer
Recording...
(visible in VCR mode only)
(See page 19.)
If head cleaning becomes
VIDEO HEADS MAY
necessary while playing NEED CLEANING |
INSER
back a tape... CLEANING CASSETTE
OR REFER TO MANUAL
(See page 5.)
END:PLAY KEY
If you push a function button
other than STOP/EJECT or | ver Lock ACTIVATED
POWER while the VCR is in
VCR Lock mode...
(See page 26.)

Panasonic Omnivision PV-7450 Specifications

General

Brand	Panasonic
Model	Omnivision PV-7450
Category	VCR
Language	English