Panasonic Omnivision PV-7450 User Manual

your TV is not stereo, you can connect a stereo amplifier to enjoy
stereo sound.
, ; :
If
your
TV
has
AUDIO
IN
and
VIDEO
IN
terminals,
you
can
connect
Audio/Video
Connections
your
VCR
to
them
to
receive
a
higher
quality
picture
and
sound.
If
Audio/Video Connections
IN FROM ANT
AUDIO IN alt OUT TO TV
! T (3-14
Model PV-7450 is shown here.
1 Connect the VIDEO OUT terminal on the VCR to the VIDEO IN terminal of your TV.
2 Connect the “L” and “R” AUDIO OUT terminals on the VCR to the “L” and “R” AUDIO IN terminals of your TV.
3 Set the VIDEO/TV selector of your TV (Monitor/Receiver) to “VIDEO.”
NOTE: To use your TV as a VCR monitor, set the VIDEO/TV selector on the TV (Monitor/Receiver) to “VIDEO.”
For model PV-7450, use the L Audio In jack for proper sound reproduction when connecting to a monaural TV.
Stereo Amplifier Connections
When you connect your VCR toa Stereo Amplifier
Stereo Component System, you
can view the picture from the VCR
while enjoying stereo from your
audio system.
Connect the “L” and “R” AUDIO
OUT terminals on the VCR to the
“L” and “R” AUDIO IN terminals of
your stereo.
VCR
Note to CATV system installer:
This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC in USA (and to the
Canadian Electrical Code in Canada) that provides guidelines for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.
O
O
5
-
0
O
c.
O
3
Y

Panasonic Omnivision PV-7450 Specifications

General

Brand	Panasonic
Model	Omnivision PV-7450
Category	VCR
Language	English