Panasonic Omnivision PV-8200 - Page 18

CO Timer Recordin
O *Important: If the remote control POWER, ACTION, PROG, CHA/® , INDEX, or ADD/DLT button does
not work when pressed, press the VCR button on the remote and try the button again.
You can set up the VCR to record a one
time, daily, or weekly program while you are
away or otherwise occupied. Up to 8
programs can be stored in memory.
¡A check list before you begin.
CJ All connections are made.
(See pages 6-9.)
O Tv and VCR are plugged in and turned on.
C VCR/TV selector is set to “VCR.”
CJ Clock is set to correct time.
LI Record tab in place. (See page 5.)
1 Press PROG* to display the
program screen.
* If a program is already in memory, press AV
and » to select an unused program number.
1, START STOP
Press AV and P to select and > KEY ie
set one of the following as the DATE:
e 1-31 =One time recording
e DAILY =Same time MON~FRI
+ WEEKLY (SUN-SAT) =Same time once a week
‘ Exa le 8—9 seueeme: a 1 y 2 DECIT] 6
Today's Date — 7 SELECTA/W Selection Order DAILY
WEEKLY... WEEKLY __ WEEKLY
(SAT) (MON) (SUN)
Remaining Items to be set:
¢ START time
* STOP time
` e CH(annel) number, or LINE
for outside source recording
» Speed (SP, LP, SLP)
3 Press AV and 44>
to select and set each
-of the remaining
items at right.
To Make Corrections
Repeatedly press > to move the cursor to the right, or « to
move to the left to the incorrect entry and make the correction.
P DT STAAT STOP CH SPD
4 Press PROG to end the program.
* This screen appears for confirmation. |? -- --:-- --:-- -- --
3 =~ mi on --
E cass, Jee
CANCEL: ADD/DLT KEY
SELECT 1-8:4 Y KEY
ENTER :» KEY
END PROG KEY
To Enter More Programs
Press AV and P to select and set a blank
program number, and then repeat steps 3 and 4.
5 press PROG to exit this mode.
6 Press POWER off to set the timer.
: ; ł
« When recording programs via a cable box, oh
make sure the cable box is left ON and ulia
tuned to the desired channel.
Multi Function Display
A cassette with no record tab is ejected and “TIMER” flashes when the power is tumed off to set the timer.
If the start times of two programs overlap, the tower numbered program will have priority.
NOTES] + Ifthe start time for a timer recording comes up during a normal recording or One Touch Recording (page 17),
the timer recording will not be performed.
If there is a power interruption of more than one minute, the recording wil! not be performed or continue.