Panasonic Omnivision PV-8451 - Page 29

‘Important: If the remote control POWER, ACTION, PROG, CHA/T, INDEX or ADD/DLT button does not
work when pressed, press the VCR button on the remote and try the button again.
If you are using a cable box and it is connected to your VCR in one of the ways shown in Connection Type A
on page 28, you will need to complete the Cable Box Setup steps below.
Cable Box Setup
Complete this page only if Type A
connection mothod (pg. 2 8 ) is used.
1 Press ACTION* to display
the menu.
2 Press AT to select “SET UP
CHANNEL,” and then press
► to display the “SETUP
CHANNEL" screen.
3 Press AT to select “CABLE/
DSS BOX SET UP,” and
then press ► to display the
“SELECT HOOKUP" screen.
4 Press AT to select your hookup,
and then press ► to set.
• If you selected CABLE/DSS BOX^
VCR^TV, continue with step 5.
If not, press ACTION three times
and turn to page 30.
5 Press AT to select your cable
box or DSS receiver output
channel number, and then
press ► to enter.
• If necessary, refer to your cable
box manual.
• If you are using AudioA/ideo jack
connections to your cable box,
select and set “VIDEO OUT" as
the output channel.
6 Press ACTION twice to end the setup and return
to the normal screen.
Go directly to “VCR Plus+ Programming” on page 31.
VCR Plus+ and PlusCode are trademarks of
Gemstar Development Corporation. The VCR Plus+
system is manufactured under license from Gemstar
Development Corporation.
29
More
You
Can
Do