Panasonic Omnivision PV-8451 - Copying Tapes (Dubbing)

Copying Your Tapes (Dubbing)
Connections you'll need to make. (Choose front or rear connection.)
• When connecting to a normal VCR, use the L Audio In jack for proper sound reproduction.
Playing (Source) VCR Recording (Editing) VCR TV for Monitoring
1 Insert a pre-recorded
tape into the Playing
(Source) VCR.
To Monitor Dubbing on Your TV
1 Turn your TV on and tune to the Recording
VCR channel (CH3 or CH4).
2 Insert a blank tape with
record tab into the
Recording (Editing) VCR.
3 Select “LINE” Input mode on the
Recording (Editing) VCR. (See “Selecting
the Input Mode” at right.)
4 Press PLAY on the Playing VCR.
Press PAUSE at the desired starting point.
5 Press REC on the Recording VCR, and then
press PAUSE immediately thereafter.
6 Press PAUSE on both VCRs at the same
time, to begin copying.
To Edit Out Unwanted Parts
Press PAUSE on the recording VCR while copying is
in progress. Press PAUSE again to resume copying.
2 Set the VCR/TV Selector on the Recording
VCR to “VCR."
Selecting the Input Mode
Press INPUT.
The display will change in the order below.
Press CH A/Y.
The display will change in the order below.
c
1 — 2 — 3'
(CABLE) (TV)
h 125 or 69-<
• LINE1: For rear audio/video connection.
• LINE2: For front audio/video connection.
• When LINE is selected, “LT or “L2" is displayed in the
Multi Function Display for about 4 seconds.