Panasonic Omnivision PV-9400

elaine) mm m-y-1del a>
The Remote Control may be set up to control some TV or Cable/DSS Box functions.
Multi-Brand Control Setup
Find your TV, Cable or DSS Receiver Brand
Code Number on following page.
3 POWER
Setup for TV Setup remote.
2 Tor
Hold down TV and enter code DSS/ CABLE
with NUMBERED keys.
Setup for Cable or DSS
Hold down DSS/CABLE and
© ® @| enter code with NUMBERED keys.
GS.) and es @ S ¢ For code 100 or greater, press the
@ © @® |] 100 key first, then remaining digit.
@ © E.g. for 102, press 100, then press 0, 2 NUMBERED
and then press 2. keys
Confirm code entry.
Press POWER to turn
selected unit ON or OFF.
* See table below for list of
controllable functions in each mode.
t Notes ] * Please repeat Multi-Brand Control setup after replacing remote
control batteries.
¢ The remote control will not operate all TVs, Cable Boxes, and
DSS receivers made by manufacturers tisted. if you get no
results, your particular brand cannot be controlled.
. : Model PV-9450 remote is shown here.
OT TTale Mm dar-M i eliigi=ie-lalem@relalice)
After remote control is setup, you can select VCR, TV, or DSS/CABLE for the desired function.
Press VCR or TV or DSS/CABLE on the remote control.
This table shows which buttons are available for each mode.
Available
REC, SPEED, ZERO/
PVR All Functions VOL UP/DOWN
= 1MIN, COUNTER.RESET
CABLE/ DSS ver Prat Fey VOL UP/ DOWN POWER, ENTER,
i-Fi -
9450 only), DISPLAY. NUMBERED keys
REW, lige ‘| (except 100key},
REC, coeEE. Seay CH UP/ DOWN
1MIN, COUNTER RESET
In TV or DSS/ CABLE mode, it may be necessary to press ENTER after pressing NUMBERED keys for channel selection.
VCR/TV, PLAY, STOP
EJECT, SAP/ Hi-Fi (PV-
9450 only), DISPLAY,
FF, REW, PAUSE, SLOW,
POWER, iNPUT,
NUMBERED keys,
ENTER, CH UP/ DOWN,
VOL UP/DOWN
14 For assistance, call 1-800-211-PANA(7262).