file:///E:/PV-9661_PV-9662/SVC/s1101020000.html
11.1.2 Mechanical Replacement Notes
TOP PREVIOUS NEXT
1. Section No. of parts shown in Exploded Views are indicated in the Remarks column.
2. Capstan Rotor Unit, Capstan Holder Unit, and Stopper are supplied as Capstan Rotor Kit (Ref.
No. 51) only.
3. Capstan Stator Unit, Capstan Rotor Unit, Capstan Holder Unit, and Stopper are supplied as a
Capstan Stator Kit (Ref. No. 52) only. However, IC2501 (AN3845SC) is available separately
as a replacement part. When installing the IC2501 or CapstanStator unit, be sure to apply
Silicon Grease (VFK1301). Refer to " Junction C.B.A., Capstan Stator Unit, Sub Rotor, and
PCB Holder " of "DISASSEMBLY/ASSEMBLY PROCEDURES OF MECHANISM"
section.
4. Main Cam Gear is supplied as a Main Cam Gear Kit only. Main Cam Gear Kit consists of a
Main Cam Gear and a Main Cam Push Nut. However, Main Cam Push Nut is available
separately as a replacement part.
5. Since the UHF/VHF TUNER/TV DEMODULATOR UNIT (Ref. No. E21) has already been
pre-adjusted at the factory, do not try to adjust the UHF/VHF TUNER/TV DEMODULATOR
UNIT. The UHF/VHF TUNER/TV DEMODULATORUNIT replacement part is available as a
complete assembly unit only.
6. The Infrared Remote Control Unit (Ref. No. 123) replacement part is available as a complete
assembly unit only. Do not try to disassemble the Infrared Remote Control Unit. However, the
battery cover is available separately as a replacement part.
7. Cut Washers (Ref. No. 417 and 441) are not reusable.
If removed, install a new one.
8. Main Cam Push Nut (Ref. No. 414) is not reusable.
If removed, install a new one.
TOP PREVIOUS NEXT
file:///E:/PV-9661_PV-9662/SVC/s1101020000.html [2006-01-28 11:14:38]
To Next Page
Loading...
