5.1.6. VCR Chassis Unit
5.1.6.1. Disassembly Procedure
1. Slide the Holder Unit (refer to "METHOD FOR
LOADING/UNLOADING OF MECHANISM" in Service
Notes) to gain access to 2 Screws (D) for removal.
2. Remove Screws (E), (F), (G), (H), (I), and Screw with
Washer (C).
3. Remove Chassis Angle.
Fig. D6-1
4. Push 2 Locking Tabs (H) inward to release while lifting the
Rear Panel.
5. Push Locking Tab (I) outward while gently lifting the left side
of the Main C.B.A. (Portion "A").
6. Lift the right side of the Cassette Up Ass'y (Portion "B") and
remove VCR Chassis Unit out of the Frame.
Fig. D6-2
Note:
1. DO NOT pull upward on the UHF/VHF Tuner/TV
Demodulator Unit because you may crack the Main C.B.A.
2. Work carefully so as not to break tabs.
5.1.6.2. Reassembly Notes
1. When installing 2 Screws (D), slide the Holder Unit (refer to
"METHOD FOR LOADING/UNLOADING OF
MECHANISM" in Service Notes) to tighten screws. Then
slide it back to the EJECT Position.
Make sure that Mechanism and Cassette Up Ass'y are in
the EJECT Position.(Refer to " EJECT Position
Confirmation" in Disassembly/Assembly Procedures of
Mechanism.)
5.1.7. Main C.B.A.
5.1.7.1. Disassembly Procedure
1. Disconnect 4 Connectors of P2531, P2552, P3501 and
P4001.
2. Carefully lift the Mechanism Chassis and Cassette Up Ass'y
straight out from the Main C.B.A.
Note:
Work carefully so as not to break Sensor LED, when lifting
the Mechanism Chassis and Cassette Up Ass'y.
21
PV-9661 / PV-9662
To Next Page
Loading...
