Panasonic Omnivision PV-9661 - Page 30

file:///E:/PV-9661_PV-9662/SVC/s0401060000.html
4.1.6 METHOD FOR
LOADING/UNLOADING OF MECHANISM
TOP PREVIOUS NEXT
(Manual Method)
Turn the Main Cam Gear counterclockwise (for loading) or clockwise (for unloading) using
needlenose pliers etc.
Note:
Do not use this method if Mechanism is jammed or locked.
Fig. 5-1
(Electrical Method)
Remove the solder as shown and apply +10.0 VDC Power Supply (DC + to Portion "a," DC - to
Portion "c").
Note:
Be careful not to let the DC Power Supply Unit GND contact the chassis GND. This may damage the
Loading Motor Drive IC (IC 2501).
Be sure to apply DC + to Portion "a" of Motor P.C.B.
If DC + is applied to Portion "b", the Loading Motor Drive IC (IC2501) may be damaged.
Fig. 5-2
file:///E:/PV-9661_PV-9662/SVC/s0401060000.html (1 z 2) [2006-01-28 11:09:06]