Antenna,,or Cable Connections
Unhook the antenna from your previous TV
or VCR and connect it to the back of the
Combination VCR as shown in the diagram.
If your antenna system has separate UHF
and VHF lead-ins, you need a UHFNHF
Band Mixer (not supplied).
(Flat)Twin Lead
300 Ohm Cable UHFNHF Band
7_5Ohm _) Mixer (not supplied)
(Round)
• -. .... or
300-75 ohm
.__ TransformerI-r-rfi_.
_n_nna (not supplied)L_
-----r__---" J Backof
(Flat)Twin Lead CombinationVCR
300OhmCable
(A) Without a Converter/Descrambler Box
With this connection, you can use your
Combination VCR remote control to select
channels for viewing and select
unscrambled channels for timer recording.
Scrambled channels may not be viewed or
recorded with this connection.
(B) With a ConvertedDescrambler Box
With this connection, you may record and
view any channel including scrambled
channels. Please note, however that
channel selection must be made at the
cable company converter box. Timer
recording is limited to one channel at a time,
and you can only view the channel you are
recording.
To Watch and Record Scrambled/
Unscrambled Channels
Set theCombination VCR to the output
channel of the cable converter box (e.g. CH3).
Now, select channels to be viewed or
recorded at the cable converter box.
(A) Back of Combination VCR
(B)
Cable TV
Converter Box
FCCWARNING: Any un_authorizedch_lngesor
modificationsto this equipmentwould void the
user's authority to operate.
v.
Note to CABLE System Installer
Thisreminderis providedto calltheCABLE
(Cable"IV)SystemInstallersattentionto Article
820-40 oftheNEC thatprovidesguidelinesfor
propergroundingand,inparticular,specifiesthat
thecable groundshallbeconnectedtothe
groundingsystemofthebuilding,as closetothe
pointofcableentryas practical.
5
To Next Page
Loading...
