The Remote Control may be set up to control some TV or Cable/DSS Box functions.
Find your TV, Cable or DSS Receiver BrandCode Number on following page.
_ Q Q
Setup
for TV
Q®Q
®
Setup remote.
Hold down TV and enter code
with NUMBERED keys.
Setup for Cable or DSS
_and C) C) (_
®Q(9
OQ®
@Q
Hold down DSS/CABLE and
enter code with NUMBERED keys.
• Forcode100or greater,pressthe
100key first,then remainingdigit.
e.g. for 102,press 100,then press0,
andthen press2.
Confirm code entry.
Press POWER to turn
selected unitON or OFF.
• See table below for list of
controllablefunctions in each mode.
_1 • Please repeat Multi-BrandControl setup after replacing remote
control batteries.
• The remote control will not operate all TVs, Cable Boxes,and
DSS receivers made byrnanutacturers listed. If you get no
results, your particularbrand cannot be controlled.
3POWER
2 ,er
DSS/CABLE
After remote control is setup, you can select VCR, TV, or DSS/CABLE for the desired function.
Press VCR or "r'v or DSS/CABLE on the remote control.
This table shows which buttons are available for each mode.
Available
Mode _-._._s VCR
VCR All Functions
"rv
CABL_DSS
VCR/TV, PLAY, STOP
EJECT, DISPLAY, FF,
REW, PAUSE, SLOW,
REC, SPEED, ZERO/
1MIN, COUNTER RESET
VCRFi'V, PLAY, STOP
EJECT, DISPLAY,FF,
REW, PAUSE, SLOW,
REC, SPEED, ZERO/
1MIN, COUNTER RESET
TV
VOL UP/DOWN
POWER, INPUT,
NUMBERED keys,
ENTER, CH UP/DOWN,
VOL UP/DOWN
VOLUP/DOWN
CABL_ DSS
POWER, ENTER,
NUMBERED keys
(except 100key),
CH UP/DOWN
In TV or DSS/CABLE mode, it may be necessary to press ENTERafter pressing NUMBEREDkeys forchannelselection.
]4
To Next Page
Loading...
