Connections you'll need to make.
IN FROM ANT,
AUDIO VIDEO
INtOI
OUT TO TV
Playing (Source) VCR
IN FROM ANT.
AUDIO VIDEO
OuTO 0
IN1 I l
OUT TO _
Recording (Editing) VCR
VHF/AUDIO IN
UHF 0
_) VIDEO IN
0
TV for Monitoring
1
t
Insert pre-recorded
tape.
t
2
%
Insert blank tape
with record tab.
Select LINE mode.
Press INPUT.
(See "Selecting the
Input Mode"below.)
3<_ PAU_SEI Put in Standby mode.
and (_=l_I Press PLAY,then
"_" I PAUSEat startingpoint.
REC PAUSE Put in Standby mode.
and G Press REC, then
PAUSE immediately.
PAUSE Start dubbing.
Q Press PAUSE.
PAUSE
®
Start dubbing.
PressPAUSE.
Stop dubbing.
PressSTOP.
<_ Stop dubbing.
Press STOP.
• To Monitor Dubbing on Your TV
1 Turn your TV on and tune to the Recording
VCR channel (CH3 or CH4).
2 Set the VCR/TV Selector on the Recording
VCR to "VCR."
_l Dubbingtapes protected Copy
with Guard willhave
poorqualityresults.
• Selecting the Input Mode
Method 1: Press INPUT.
Channel Number <--> LINE
Method 2: Press CH AJV.
Display will change as below.
('___,LINI: 2_CA.3_LE' or (6T_)_
• "L"lights on Multi-Function Display (about 4 sec.)
when LINE is selected.
Caution: Unauthorized exchanging and/or copying of copyrighted recordings may be copyright infringement_
]9
To Next Page
Loading...
