A. Rotate the Lift Gear so that Hole A on Lift Gear is a Through Hole
with a hole on chassis.
B. Install the Intermediate Gear A so that the hole on Intermediate Gear
A is aligned with the hole on Lift Gear.
C. Install the P5 Arm Unit so that it contacts with the tab of chassis.
Fig. J10-2
2. Installation of Opener Piece
A. Install the Opener Piece so that the slot of the Opener Piece is
inserted to the Pin of Pinch Arm Unit
Fig. J10-3
5.2.13. Motor Block Unit, Audio Control Head Unit, Lift Gear, Tension Arm Boss, and
Cleaner Arm Unit
Fig. J11
33
To Next Page
Loading...
