Function & Channel Displays
c_0e When a function button
is pressed, e.g. PLAY, or
you change channels,
a 5 second display
appears.
Blank Tape/
No Video Signal Indications
Whenblanktape isdetectedduringplay,
orthecurrentchannelhas nosignal(with
WeakSignalDisplayfeature (p. 10)setto
OFF),the TV screenwillturnsolidblue.
VCR Status & Clock Displays
To display or remove Function Status
overlay at right,
÷ press DISPLAY*. Rec
(OTR mode only.
See p. 5 of Basic
Operationsbook.)
Broadcast Audio
Being Received
(For Model PV-V4522 only)
Current Time
_ Channel
I .....m_-_ Counter
J Tape Speed
(See p. 3 of Basic
Operationsbook.)
These displays will alert you to a missed
operation or provide further instructions.
OSD
PLEASE SET CLOCK BY
PRESSING ACTION KEY
TURN VCR OFF
FOR TIMER RECORDING
CHECK CASSETTE
RECORDTAB
NO CASSETTE
TO CANCEL TIMER REC
PRESS POWER THEN
STOP KEY
VIDEO HEADS MAY
NEED CLEANING
PLEASE INSERT HEAD
CLEANING CASSETTE
OR REFER TO MANUAL
END :PLAY
VCR LOCK ACTIVATED
REMOTE CONTROL IS SET
TO TV MODE
USEVCR:VCRKEY
Caution
If you attempt to set or review a Timer
Recording and the Clock is not set...
After a Timer Program has been set...
If you press REC on the remote
control or VCR, and a cassette is
inserted with no record tab...
If you press PLAY, FF, REW, or REC
on the remote control or VCR without
a cassette inserted...
If you press POWER or STOP during
a Timer Recording...
(visible in VCR mode only)
If head cleaning becomes necessary
while playing back a tape...
If you press a function button other
than STOP/EJECT or POWER while
the VCR is in VCR Lock mode...
If you pressan invalidkey on the
remotewhilein TV mode...
Page
See page 6 of
Basic Operations
book
See page 6 of
Basic Operations
book
See page 3 of
Basic Operations
book
See page 5 of
Basic Operations
book
See page 6 of
Basic Operations
book
See page 3 of
Basic Operations
book
See page 10
See pages 2, 10
*important: if a remote control button does not work when pressed,
press the VCR button on the remote and try the button again.
-11 -
To Next Page
Loading...
