Please make all cable or antenna connections before plugging Into the AC
outlet.
Pluggingthe VCR PowerCord Intoan AC walloutletstartsautochanneland clockset.
For ANT./Cable --- VCR -_ TV
VCR IN FROM ANT
(_ Connect cable from Tv
Antenna/Cable to VCR's IN _ ,,,ro_
FROM ANT. jack. _ '_,BLE
_) Connect VCR's OUT TO TV _. ooTTow
jack to TV's ANT. IN jack
with included RF Cable
accessory.
VHF/UHF
For DSS/Cable Box -,- VCR -_ TV
(I)Connect your cable box's
OUT jack to the VCR's IN
FROM ANT. jack with an RF
cable.
(_ Connect VCR's OUT TO TV
jack to TV's ANT. IN jack
with included RF Cable
accessory.
TV VC R IN FROM ANT. CaL4_ TV
Com_t_r 15ox
m
1Turn TV on and tune to channel 3.
2 Plug VCR Power Cord Into AC wall
outlet. VCR comes on and auto
channel and clock set starts.
• ff screen below does not appear, check
VCR - TV connection and, if TV is
tuned to channel 3. try switching it to
channel 4.
• To change VCR's output channel,
please refer to "VCR's Output Channel"
in Advanced Operations book (p. 12).
3Settings are made automatically.
When setup is done, this screen
appears.
If "AUTO CLOCK SET IS INCOMPLETE"
appears, manually set clock.
See below.
VC_VCR CLO(_K CHANNEL
] Plugging the AC Power Plug into an AC outlet I
!_h'1";I1_1[eJlI_'4R_Jil
_ CANCEL :STOP
AUTO CLOCK SET
P_ _EEDING
STOP
If you use a cable box, turn it on and set it
to the Public Broadcasting Station (PBS)
channel in your time zone. If you use DSS
receiver, it must be turned off.
If Auto Clock Set was incomplete.
1 Press ACTION* on remote to display
CLOCK menu.
2 Press • • to select the month and I_
to set. In the same manner, select and
set the date, year, time, and DST
(daylight saving time).
WARNING
Over tightening "Nut type* RF coaxial cables I _ Press ACTION to start clock and exit.
f
may damage jacks. Finger tighten only.
i
-4-
To Next Page
Loading...
Need help?
General