1 1) Press PROG*.
2) Press • to display program screen.
1) Set record DATE,
press AV to select:
1-31= one time,
or DAILY= MON~ FRI,
or WEEKLY= same time
each week and press •.
2) Set remaining items,
press A.• to select and
Examole
Today
L 8--9...-....31-- 1 -- 2,..... 6
7 SELECTA I • S_dectionOrder DALLY
LwEE+
(SAT) ...... (MON) (SUN)
press • to set START/STOP times,
CH(channel) or LINE input (p. 3), and
tape speed (p. 3).
Press PROG to end programming.
To Enter More Programs
Press &v to select and
:_ :::: :z__- :: :: press I_ to set an unused program._E,_c_,_,o_,_ Then repeat step 2.
....... Or, press PROG to exit.
4 Press POWER off to set the timer. ("TIMER" lights on Multi Function Display.)
I p,l :.MI [_Td_ =p,J 11 p. I t_ kll • I ILll'] _ ;I l[ll+ IIP;.I I I
(Recording is not in progress)
a 1) Press PROG.
2) Press ,<11_to select LIST.
b Press AV to select
desired program.
limP,::.+%,o++
_ ¢_:mL :ACOlC_T
SEU_CT • • SEI ..
mXlT :PmO_
C To Replace program...
,+-,,_ _ 1) Press • to display.
2) Repeat Step 2
(above) to set new
.... programs.
or
To Clear program...
/_,_ _ Press ADD/DLT.
L.........
gu _ _ mo_ kl Lp_
C_L :ADDICT i
i _LE¢ _r :A • SE_
d Press PROG to end the program.
|Ipl I 1_.I'..IIt_l I Ii I[_ II ;'[:;•[e) (_+II l[_ i
(Recording is in progress)
Press POWER and then STOP within 10
seconds to cancel the Timer Recording.
(The TIMER indicator goes out on Multi
Function Display.)
• If you are using a Cable Box, VCR Timer Programming Channel (Step 2 above) must
be set to the Cable Box output channel and your Cable Box must be manually set to
the desired channel The Cable Box must be left on.
• If a power interruption occurs while programming the timer, the timer program(s) may be
canceled. If "TIMER PROGRAMS WERE LOST DUE TO POWER INTERRUPTION" appears
on-screen, please reenter the timer programs.
Important notes when using DSS receiver
• When recording programs via DSS receiver, DSS receiver must be left on.
• When recording programs via an antenna or cable, DSS receiver must be turned off.
-6-
To Next Page
Loading...
Need help?
General