Panasonic Palmcorder PalmSight PV-L857 - Page 25

Play Back your Recordings
Playback using the LCD Monitor
You
can
also
use
the
LCD
monitor
to
Before
you
begin
| r recording.
playback your recording » Connect the Palmcorder to a power source.
* Insert a recorded cassette.
* Set the POWER switch to VCR.
1 Press the LCD-OPEN button to unlock
the LCD monitor and swing open.
2 Set the LCD-POWER switch to AUTO
ON. The LCD monitor will then turn on/
off according to the Palmcorder’s
POWER switch setting.
* When the LCD monitor is turned ON,
the Viewfinder automatically tums
OFF.
* When not in use, close the LCD
monitor. (Faces inward)
AUTO ON
LE
Es | r
3 Piayback the tape (see page 24).
* Adjust the volume of the speaker or
earphone (if connected) using the
VOLUME control.
Asa the LCD-POWER switch to OFF to
have Viewtinder on only when viewing is
finished.
* When the LCD monitor is completely
as closed, it will shut off automatically to
j save power even if the LCD-POWER
switch is left on.
* When the LCD monitor turns off, the
Viewfinder turns on automatically,
PHONE (earphone)
jack
Note:
* Using the LCD monitor reduces battery
operating time.
* If you connect the earphone (M3 type, not
supplied) to PHONE (earphone) jack, the sound
from the speaker will be muted.
25