Panasonic Palmcorder PV-S64 - 8-Function Remote Control; Remote Operation and Battery Replacement

Operate tiqemajor lunctiulls ot your Palmcorder
from up to 16 feet (5 m) (approx.) away.
"Remote Control_
• j
Signal
]
2
3
Remote Control
REPLACE BATTERY
WITH PANASONIC PART
NO. VSBW0004 (CR2025)
ONLY. USE OF
ANOTHER BAT'rER¥
MAY PRESENT A RISK
OF FIRE OR EXPLOSION
CAUTION-BATTERY MAY
EXPLODE IF
MISTREATED. DISPOSE
OF USED BATTERY
PROMPTLY. KEEP AWAY
FROM CHILDREN.
DO NOT RECHARGE,
DISASSEMBLE OR
DISPOSE OF IN FIRE.
To remove, slide the Remote Control
switch to eject the Remote Control.
To store, insert the Remote
into the slot until it locks into place.
Select the REMOTE ON position on the
Remote.
Aim at the Remote Sensor and press the
desired buttons.
VCR CAMERA
Controlled Functions MODE MODE
REC/PAUSE - o
iT(telephoto) Zoom - o
W(wide angle) Zoom - o
PLAY o -
FF/SEARCH o -
REW/SEARCH o -
STOP o -
STILL o -
• After 5 minutes in the Rec/Pause mode,
the Palmcorder will go into the Standby
mode (power will shut off) to conserve
battery life.
In this case, press REC/PAUSE down
for about one second, the Palmcorder
comes back on and goes into the
Record mode.
• Select the Remote OFF position on the
Remote when not in use.
] _While pinching the stopper tab,
®pull the Battery Tray out.
Insert the battery (supplied) into the
, BatteryTray with the(_ mark facing
up,
Do not reverse the polarity.
3
Replace the Battery Tray.
• For Battery replacement, set the
Remote Power switch to OFF.
19