E
SELE
C
T
:
SET
:
END
:
P
R
O
G
/
ACT
I
ON
Press PROG twice (or ACTION)
to exit this mode.
2
3
To Replace program...
To Clear program...
4
Press to select
the desired program.
1) Press to display.
2) Press to select
and press or
to set new program
contents.
3) Press PROG (or
ACTION).
Cancel a Timer Recording:
(Recording is in progress)
Hold down STOP for a few seconds
to cancel the Timer Recording.
• Any future daily or weekly recordings
will be performed as programmed.
Press ADD/DLT.
Review, Replace or Clear Program
Contents : (Recording is not in progress)
• 2 minutes before Timer recording is performed,
“PLEASE PREPARE FOR TIMER REC” appears and/
or the PROG TIMER Indicator flashes. Be sure a
cassette with record tab is loaded and the unit is in
Stop mode.
• If the start times of two programs overlap, the lower
numbered program will have priority.
• If the start time for a Timer Recording comes up during
a normal recording or One Touch Recording (page 12),
the Timer Recording will not be performed.
• If there is a power interruption of more than one minute,
the recording may not be performed or continued.
• If “INCOMPLETE” appears after all items have been
set, check all entries and make necessary corrections.
Notes
SELECT/SET
:CH UP
:CH DOWN
:VOL UP
:VOL DOWN
ADD/DLT
PROG
STOP
P DT
STA
R
T
ST
O
P
CH
S
PD
1
To Next Page
Loading...
