Panasonic PV-C2022

8
2 / 6 / 2002 W ED 12 : 00 P M
DST : O N
A UTO C L OCK SET
CO M P L ETED
SETT I N G : CH 1 0
If AUTO CLOCK SET IS
INCOMPLETE screen
appears, set the clock using
MANUAL CLOCK SET
procedure as below.
SET :
START : ACT I O N
SET
C L OC K
DST : O N
SE
SE
T COMPLETED
COMPLETED
2 / 6 /
2 / 6 /
:
2002
2002
WED
WED
12
12
00
00
PM
PM
Connections/ Initial Setup (Ready to Play)
How to Connect
Initial Setup (Ready to Play)
1
Plug the unit power cord into an
AC wall outlet.
Press Power* on the remote or
unit. The unit comes on and auto
channel and clock set starts.
• If you use a cable box, turn it on and set it to the
Public Broadcasting Service (PBS) channel in
your time zone. If you use a DSS reciever, it
must be turned off.
Settings are made
automatically. When setup is
done, this screen appears.
For ANT./Cable
Connect the cable from Antenna/
Cable to the VHF/UHF terminal
on the unit.
For DSS/Cable Box
Connect the OUT jack on your
cable box to the VHF/UHF
terminal on the unit with a RF
cable.
VHF/UHF
VHF/UHF
UNIT
IN from
ANT./CABLE
VHF/UHF
WARNING:
Overtightening "Nut type" RF coaxial cables
may damage jacks. Finger tighten only.
Please make all cable or antenna connections before powering on.
VHF/UHF
VHF/UHF
Cable TV
Converter Box
CH AUTO SET PROCEEDING
PROCEEDING
AUTO CLOCK SET
CANCEL : PRESS STOP KEY
3
Connecting
IN from
ANT./CABLE
2
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
LSQT0517A_01p09.p65 11/20/2001, 9:05 AM8