Panasonic PV-C2541 - Page 11

«Important:
if a remote control button does not work when pressed, press the COMBO button
on the remote and try the button again.
Press CH A Key to start
CHANNEL / CLOCK AUTO SET
operation. Settings are performed
automatically. If the setup is
completed, the following screen is
displayed.
21 7/2001 WED 12:00PM
DST: ON
SETTING : CH 10
AUTO CLOCK SET
COMPLETED
END : PRESS CH UP KEY
If AUTO CLOCK SET IS
INCOMPLETE screen appears, set
the clock using MANUAL CLOCK
SET procedure on page 9.
AUTO CLOCK SET
1S INCOMPLETE
PLEASE SET CLOCK BY
PRESSING ACTION KEY
Cable Box Setup
1) Press ACTION.
2) Press AVP to select "CH."
H Plus
SELECT:A Y
SET >
END :ACTION
4) Press AV to select
CABLE BOX SET UP and press b.
COMBO
SELECT/
SET
4:CH UP
v:CH DOWN
>:VOL UP
4:VOL DOWN
ARE YOU USING
A CABLE BOX?
YES
INO |
5) Press AY to select "YES" or "NO"
and press p.
* |f you select...
B "YES" > Step 6).
B "NO" > Press ACTION three times to exit.
E
NTER CABLE BOX OUTPUT
CHANNEL
6) Press AV to select the same channel as
your cable box or DSS receiver output
channel, then press P.
* If necessary, refer to your cable box manual.
* If you are using Audio/Video jack connection
for your cable box, select and set "VIDEO
OUT” as the output channel.
7) Press ACTION
three times to exit.
11