Panasonic PV-C2541 - Page 19

«Important:
if
a
remote
control
button
does
not
work
when
pressed.
press
the
COMBO
button
on
the
remote
and
try
the
button
again.
MEE SLEEP TIMER
SET This unit can be set for auto power off.
a:CH UP Press SLEEP repeatedly
":CHDOWN to set SLEEP TIMER. SLEEP pes 30
»:VOL
UP
*
Pressing
DISPLAY
with
3 4:VOL DOWN sleep timer set displays SLEEP TIMER 60
V I-PROGNCR« remaining time. SLEEP TIMER 90
Press SLEEP repeatedly
until “SLEEP TIMER 00” SLEEP TIMER 00
appears to cancel.
INSTANT ALARM
You can set a timer alarm up to 60 min. Useful when
you are cooking, etc.
Press TIMER/FM on the unit to display
the instant alarm CANCEL/SET screen.
Press CH AY on the
unit with CANCEL/SET
screen displayed to set
alarm. (Time changes in
the order shown left.)
uoneiado AL
CANCEL: ADD/DLT 02:0
SET:CH A Y KEY ON UNIT N
i 1:00 (one minute) -----;
i epa one-minute
i 3:00 increase * Pressing TIMER/FM repeatedly on the unit
TE until 10:00 will change display as follows.
; ux i TV INSTANT ALARM [FW |
7
10:00
III
>]
Screen
Display
|
Screen
Display
|
ioe (or LINE) FM
' D five-minute
' ROM an 30:00 To cancel, press TIMER/FM then press ADD/DLT on
57 i the remote while CANCEL/SET screen is displayed.
a A 2; To increase timer in progress, repeat step 2. Time
1
40:00
ten-minute
will
be
rounded
up
to
next
1,
5,
or
10
minute
interval.
it increase (See chart left.)
50:00 until 60:00
+. 60:00 (Max) - --4 «Example»
* [f current time remaining is 12:15, countdown will
restart from 15:00.
* If current time remaining is 9:15, countdown will restart
from 10:00.
ID ene Alarm will sound at 0: 00.
While timer function is in progress, Press any button to stop
you can change channels on the
unit with CH AV while “CANCEL/
SET” screen is not displayed.
¢ The volume of the alarm gradually increases for
one minute and then continues to beep until
any button is pressed.
19