Panasonic PV-C2541 - Page 9

«Important: ifa remote control button does not work when pressed, press the COMBO button
on the remote and try the button again.
CHANNEL / CLOCK AUTO SET
operation Settings are performed
automatically If the setup is
completed, the following screen Is
displayed
2/ 7/2001 WED 12 OOPH
DST ON
SETTING CH 10
AUTO CLOCK SET
COMPLETED
END PRESS CH UP KEY
If AUTO CLOCK SET IS
INCOMPLETE screen appears, set
the clock using MANUAL CLOCK
SET procedure as below
4 Press CH À Key to start
AUTO CLOCK SET
= IS ¿NCOMPLETE
PLEASE SET CLOCK BY
PRESSING ACTION KEY
MANUAL CLOCK SET
If AUTO CLOCK SET was incomplete,
manually set the clock as follows
1 Press ACTION Key on the Remote
to display SET CLOCK Menu screen
SELECT MONTH
SELECT 4 Y
SET >
END ACTION
2 Press A V to select the month and
press P to set In the same manner,
select and set the date, year, time,
and DST (Daylight Saving Time)
SET CLOCK
2| 7/2001 WED 12:00PM
SELECT COMPLETEO
SET <>
END ACTION
3 Press ACTION Key twice to start
CLOCK and exit
COMBO
4 VOL DOWN
Reset all unit Memory Functions
When moving unit to a new location, or if a
mistake was made in the Initial Setup
section,
* Make sure a tape 1s not inserted in the unit
:
1 Turn the unit
Power on
2 Press and hold both PLAY and
FF on the unit for more than 5
seconds
e The power will shut off
* Please ignore "NO CASSETTE"
warning
3 Do "Initial Setup" on page 8