Panasonic PV-DV950 - Using the Remote Controller; Camera and Remote Controller Setup; Selecting Remote Controller Modes

Using the Remote
Controller
1 Set the
[POWER ON/OFF]
Switch
on the
Movie
Camera to [ON].
•
When the
[CAMERA]
Lamp lights,
you can
use the
recording functions.
O
•
If you want to use the
playback
functions,
press
the
[VCR/CAMERA]
Button
so that the
[VCR
J
Lamp
lights.
0
2 Aim the Remote
Controller at the
Remote
Control
Sensor
on
the Movie
Camera
and press the
appropriate
button.
Distance to the Movie
Camera: Less than
5
metres.
Angle:
Approximately
15°
up, down, left
and right
from center
axis.
The
operative
range described
above
is valid for using
the
Remote
Controller
indoors.
When
using
it outdoors
or
under strong lights,
it
may
not work
correctly
even within
the above
range.
• Within
a distance of
about 1 metre, it
is also
possible
to
use the
Remote
Controller from
the side
(LCD
Monitor
side).
Selecting the
Remote
Controller
Mode
When using
two Movie
Cameras
at the same time,
selecting
different
Remote
Controller
Modes
makes it
possible
to operate
them
separately.
If the
Remote
Controller
Mode
set on the Movie
Camera and
on
its
Remote Controller are not
matched,
the [REMOTE] Indication appears.
Replacing
the button-type battery in
the
Remote
Controller
may reset
it to
the [VCR1]
Mode.
•
Set [REMOTE] on the
Menu
to the desired
Remote
Controller
Mode.
(«+
62-64)
©
Press the
[-t]
Button and
the
[]
Button
simultaneously.
This
selects the
[VCR2]
Mode.
O
Press the [I-]
Button
and the
[]
Button
simultaneously.
This
selects
the [VCR1]
Mode.
-54-