It normally takes approx. 6 seconds to unload the Mechanism from fully-loaded position to
EJECT position.
Fig. 4-1
4.1.5.2. (Manual Method) without Cabinet Parts
Turn the Gear of Reduction Gear Unit clockwise (for loading) or counterclockwise (for unloading)
manually.
It is necessary to rotate approx. 80 times from fully-loaded position to EJECT position.
Fig. 4-2
4.1.6. HOW TO REMOVE A JAMMED TAPE
CAUTION:
If loading does not start after DC Power Supply is applied, DO NOT
17
To Next Page
Loading...
