5. Open the Cassette Cover fully.
6. Remove the tape slack by rotating the Takeup Reel Gear of the
cassette tape.
Fig. 5-3
7. Take out the cassette tape.
8. Connect the Power or Battery to set the Mechanism to STOP
Position.
4.1.7. HOW TO USE TP BOARD
4.1.7.1. TP Board is required when:
1. performing "TAPE INTERCHANGEABILITY ADJUSTMENT."
2. performing "PC-EVR Adjustment."
3. the cassette tape is jammed. Refer to "HOW TO REMOVE A
JAMMED TAPE."
4. loading or unloading the Mechanism (Electrical Method).
5. performing a signal check.
4.1.7.2. How to assemble TP Board:
1. Assemble the TP Board as shown.
Fig. 6-1
19
To Next Page
Loading...
