To hold the Cassette Up Unit in the down position without it, a Lock Screw is needed.
4.1.2.1. How to install the Lock Screw:
1. If the Lock Lever, shown in gray, is set to Position "A" (No hole),
change Position "A" (No hole) to Position "B" (Hole) as shown in
Fig. 2-2 by pushing Portion (a) as shown in Fig. 2-1.
Note:
If the mechanism is in EJECT position, the Lock Lever cannot be
changed to Position "B" by pushing Portion (a). In this case, apply
power to set the mechanism to STOP position.
Fig. 2-1
Fig. 2-2
7
To Next Page
Loading...
