2. Install the Lock Screw in the Hole (Threaded Hole for Lock Screw
access) in Position "B".
3. Hold down the Cassette Up Unit and confirm that the Cassette Up
Unit will stay in the down position.
Note:
If the Cassette Up Unit will not stay in the down position, slide the
Lock Lever to the right slightly.
4.1.2.2. Lock Screw is required when:
1. performing "TAPE INTERCHANGEABILITY ADJUSTMENT."
2. servicing with cassette tape in Service Position. The procedure
below is required when the unit is in safety defeat mode.
A. Confirm that the Lock Lever, shown in gray, is set to Position
"A" as shown in Fig. 2-1, and that the mechanism is in the STOP
position.
B. Insert the cassette tape.
C. Push Portion (a) as shown in Fig. 2-1 while keeping the
Cassette Up Unit in the down position so the mechanism starts
loading. (Cassette Down Switch is ON.)
8
To Next Page
Loading...
